FACE FIXING SHUTTERS:
Shutter Width
Measure the opening width. From each edge of this opening width 60mm of shutter guide rail is required on each side. (this is the full shutter width, overall guide width)
Shutter Height
Measure the height from counter/bar top to underside of opening. This is the guide height, add the shutters box size, headroom. (This is the shutters Total height.) The box, headroom is dependent upon the height of the shutter- see (shutter door box sizes below) for required sizes. When the door is fully raised, a minimum of 55mm bottom slat hangs down into the guide rails. This is the shutter opening height
REVEAL FIXING SHUTTERS:
Shutter Width
Measure the reveal opening width. 60mm guide rails on each side are inclusive of the reveal opening width, (this is the full shutter width, overall guide width)
Shutter Height
Measure the height from Counter/bar top to underside of opening. If the shutter is installed within the recess, the height of the shutter box will be included in the shutter height. (This is the full shutter total height) When the door is fully raised, a minimum of 55mm bottom slat hangs down into the guide rails.
Installation:
On most installations the shutters box can be enclosed behind the lintel, providing there is enough space to accommodate the shutter box. The shutter box can roll inside or outside of the bar area. On some applications if the width is to wide then two shutters will have to be installed with a removable guide post.( see details below.)
