EASY-TO-FIT INDUSTRIAL DOOR SHUTTERS
Measuring Instructions
The shutters may be installed either inside or outside the property. (chain operated internally fitted only) The shutters are installed upon the face of the opening or the recess of the opening. If the shutter is installed within the recess, the height of the shutter box will be included in the shutter height. When the door is fully raised, a minimum of 55mm bottom slat should hang down into the guide rails. The guide rails on each side of the shutter are 65mm wide. (It is recommended that from each edge of the opening width the guides and angles are set on 75mm.)The box is dependent upon the height of the shutter - see (shutter door box sizes below) for required sizes. For face fitting, the guide rails are added to the opening width; for recess fitting, the guide rails are inclusive of the opening width.
Manual operated shutter (measure the brick opening width and the overall opening height as per diagram below.)
Electric operated shutter (measure the brick opening width and the overall opening height as per diagram below.)
Shutter Door Box sizes: Galvanised solid or Perforated (maximum shutter height including box for each box size)
Shutters up to 1200mm high
|
|
Shutters up to 2400mm high
|
Shutters up to 3400mm high
|
Chain operated shutter (measure the brick opening width and the overall opening height as per diagram below.)
Shutter Door Box sizes: Galvanised solid or Perforated (maximum shutter height including box for each box size).
Shutters up to 2730mm high
|
|
Shutters up to 3626mm high
|
Shutters up to 5000mm high
|
|
